Running Plumbing Through Floor Instead Of Outside Wall

Sometimes the wall is insulated but not the rim joist between floors and you get freezing there.

Running plumbing through floor instead of outside wall.

Running drainpipe through joists calls for meticulous work. While homeowners may fret over running plumbing lines through the ceiling it is a common practice used to minimize damage during the re plumb and to keep labor costs lower. Placing water pipes in outside walls greatly increases the risk of frozen and burst pipes in cold climates. Run the horizontal vent lines sloped downward toward the fixtures at a rate of 1 8 to 1 4 inch per running foot.

We re all taught not to run plumbing in exterior walls. This needs to extend through to the roof. Instead of running from floor to ceiling a soffit runs across the top of a wall. When running pipes from a slab to an attic use an inside wall.

I live and work in the cold boston area. In most cases the lines will come through the floor. Similar to the chase is the soffit. Or just a little breeze of cold air such as a crack in a crawlspace or top of a basement wall is just enough to freeze a couple of inches of pipe.

Inside pipes can be run vertically to accommodate new plumbing. When running the pipes through the studs first be sure to drill the holes in the center so that when it s time to hang the wall board the screws or nails don t reach the pipes and damage the pipes. When you need plumbing in exterior walls. When remodeling bathrooms we always plan to install all plumbing lines inside interior walls and avoid running plumbing in exterior walls due to the reality of the pipes freezing.

If joists are 16 inches on center and pipes run across them at a right angle holes should differ in height by about 3 8 inch. Use a carpenter s level to mark the studs for drilling holes. If you are plumbing a vanity consider coming up through the floor rather than in the wall. Drill holes cut pipes and connect them in a dry run using drain fittings.

Step 7 vent the waste lines. And pipes running straight through wood studs and joists are fine too just protect the pipe in areas where it bends as it passes through. The holes must follow a straight line across the floor and must ascend or descend so the pipe will be sloped 1 4 inch per foot. You need to make sure that you use black plastic that is 1 1 2 inch in size.

The chase is most commonly used for running new vent stacks. This allows plumbing to run from the basement to the attic. If your pipes are going in a lateral direction make notches in the studs instead of drilling holes in them. Often the most economical way to replace the original plumbing is running pvc cpvc or pex tubing through existing walls ceilings and crawl spaces.